Units AS 200 Tool cleaning and water recycling unit The world-wide one and only patented and mobile compact unit with minimal dimensions European Patent No. 0613707 A compact unit with an integrated water recycling system Mode of Operation Cleaning parts The cleaning of tools, appliances, canisters etc. is carried out by using running water with a water pressure of approximately 3 - 4 bar. For this purpose the water is, by means of a pump integrated into the unit (4), transported from the lower clear water container (5) into the washing area (1) of the processing container (2), which then adopts the function of a wash basin. The water which has been polluted through the cleansing process is then collected in the processing container (2). Water processing When the processing container (2) is filled with dirty water, the agitator is switched on, and the separation agent is added. After the agitator has automatically switched off, the residue settles at the bottom within a few minutes. The clean water is then drained through a swivelling over-flow pipe to the lower clear water container (5) and is then ready to be used for further cleaning. Draining the residue To remove the residue you simply have to tip the processing container. This allows the residue to flow into the filter where the remaining water is drained. At this point the unit is ready to be used for further cleaning. The filtered residue can be disposed off as dry material according to official regulations. Technical data AS 200: Volume/litres of foul water container: approx. 200 l Volume/litres of clear water container: approx. 200 l Volume/litres of filter box: approx. 60 l Power supply: 230 V / 50 Hz Fuse: 10 A by Fl safety switch Length x width x height / mm: 1200 x 670 x 1100 Weight: approx. 45 kg The principle of precipitation and flocculation with our high-grade fission powder aquafloc* Top