AS 200 Tool cleaning and water recycling unit Europe-Patent Nr. 0613707 The compact unit with an integrated water-circulation system Washing & cleaning of Paint rollers · Containers · Airbrushes · Tools · Pumps To recycle wastewater from Water lacquer · Glue processing · Latex paint · Oily emulsions Function 1. Partial cleaning DThe cleaning of tools, appliances, canisters, etc. is carried out using running water with approximately 3 - 4 bars of water pressure. For that purpose, the water is, by means of a pump integrated directly into the unit, advanced from the lower water container, which then assumes the function of a wash basin. The water which has been polluted through the cleansing process is collected in the processing container. 2. Water processing When the processing container is filled with dirty water, the agitator is switched on and the separation agent is added. After the agitator has automatically switched off, the residue settles at the bottom within a few minutes. The clean water is then drained through a swivelling over-flow-pipe to the lower clean water receptor where it is available for further use. the way our fission powder aquafloc* 7 works 3.Emptying of the residue By removing both stoppers the entire content runs within a few minutes into the filter container. The residue stays in the filter where the remaining water is drained. At this point, the unit is ready to be used for the next cleaning. The filtered residue can be disposed of as dry material according to official regulations. Technical data AS 200 Volume of dirty water container: approx 200 liters Volume of clear water container: approx 200 liters Volume filter container: approx 60 liters Power supply: 230V - / 50Hz Fuse: 10 A by FI safety switch L x W x H:: 1200 x 670 x 1100 mm Weight: approx 45 kg AS 80 · AS 200 · AC 400 · Home · Contact / Impressum · E-Mail Aqua-Service Industriewasserrecycling GmbH